Fresh dry-in
New underlayment covers the whole roof doubled or self-adhered where needed.
Tile Roofing
Tile Roof Replacement Boonton, NJ
A roofer in Boonton can replace a worn tile roof by removing the tile, repairing the deck, installing new underlayment and flashing, then relaying the sound tile or putting on new tile. One call to (862) 420-3040 reaches a nearby tile roofer.
Replacing a tile roof is different from replacing a shingle roof, because the tile itself may still be good. When the tile is sound, the replacement is really a rebuild of the roof under the same tile, often called a lift-and-relay or a tile reset. When the tile is brittle, badly eroded or no longer available, new tile goes on instead.
Either way, the job follows the same order. The tile comes off and is sorted, the old underlayment and battens are stripped, soft decking is replaced, and new underlayment, battens and flashing go down before tile is laid back on. A building permit is usually required, and the inspector may check the underlayment before tile goes back on.
Some tiles always break on the way off. Older tile is brittle, so a portion breaks during removal and has to be replaced with matching tile. Ask how many tiles the roofer expects to lose and where replacements will come from.
Depending on what the roofer finds, tile roof replacement in Boonton, NJ can go hand in hand with tile roof installation and tile roof repair.
Need tile roof replacement in Boonton? Call (862) 420-3040 and describe the problem to a roofer who works in Boonton.
Call nowThe process
What happens during a tile roof replacement
Here is how a tile roof replacement typically goes.
Decide on the tile
A close look at the tile, the underlayment and the decking decides whether the tile goes back on or new tile is ordered. A roof with large sags should be checked from below before anyone walks on it.
Strip the tile
Tile is pulled course by course, sorted and stacked on the roof or on pallets, with broken pieces set aside. Sections are opened only as fast as they can be dried in again.
Strip to the deck
Worn felt, old battens, fasteners and flashing are stripped so the deck is bare. Soft or rotted decking is cut out and replaced with new plywood or OSB.
Install new underlayment
A modern underlayment system is installed along with new flashing at every valley, wall, chimney and pipe. New battens and new bird stops go on before the tile.
Relay the tile
The salvaged tile is relaid course by course with corrosion resistant fasteners, and new or salvaged tile fills any gaps. If new tile was chosen, it goes on the same way over the new layers.
Close the roof
The ridge is finished, spare tile is left for future repairs and the heavy debris is hauled away. The permit is closed with a final inspection where required.
What is included
A full tile roof replacement
Valley metal
Valleys, walls, chimneys and pipes get new flashing sized for the tile profile.
Tile removal
All tile is removed and sound pieces are saved for relaying on the new roof.
New tile
Sound tile goes back on, blended with matching replacements and finished with new ridge caps.
Sheathing replacement
Damaged sheathing is cut out and renewed to carry the weight of the tile.
Related service
Tile Roof Underlayment Replacement Boonton, NJ
Underlayment replacement is the job most older tile roofs need, even when the tile looks nearly new. The original underlayment on many roofs was a single layer of felt that dries out, cracks and tears after a few decades of heat under the tile. Modern options like self-adhered membranes and heavy synthetics are built to last far longer.
For tile roof underlayment replacement in Boonton, the roof is usually done slope by slope so tile can be stacked on the next area while the deck is open. It is the right time to replace valley metal, wall flashing and battens too. The result is a roof that keeps its original look over a brand new waterproof layer.
Related service
Clay Tile Roof Replacement Boonton, NJ
With clay tile, the first question is whether the tile itself still has life left. Good clay is hard and holds its shape, while tile that has spalled, delaminated or turned soft is better replaced. If too much tile has failed, new clay in a close profile and color can replace it.
Clay tile roof replacement on a Boonton home is as much about appearance as protection, especially with older profiles. Roofers often move original tile to the most visible slopes and use matching new or salvaged tile on the rear.
Local help
Tile Roof Replacement Near Me
Many tile roofs in Boonton were installed decades ago, and a lot of them are reaching the age when the original underlayment gives out. In Boonton and neighboring areas including Lake Hiawatha, Mountain Lakes, Parsippany and Towaco, storm damage and age are the two main reasons tile roofs come due, so a look under a few tiles is the first step in planning any replacement.
Need tile roof replacement around Boonton? Call (862) 420-3040 for a Boonton roofer who serves the towns around it too.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Boonton, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Drier ceilings
Small roof problems caught early usually stay small repairs.
Roofers who know Boonton
Local roofers see the same roofs and storm damage across Boonton and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about tile roof replacement
When is a tile roof past repair?
The signal is leaks in several places plus underlayment that is brittle wherever tiles are lifted. One leak or a few broken tiles is repair work. A roofer can lift tiles in several spots to show the condition underneath.
What does relaying a tile roof mean?
Relaying a tile roof keeps the tile but replaces everything under it. It makes sense when the tile still has decades of life and the layers below do not.
How long does a tile roof replacement take?
A tile roof replacement takes longer than a shingle reroof, often a couple of weeks or more for an average home. Deck repairs, structural work and finding matching tile can extend it. The roof is dried in section by section, so the house stays protected.
Can a tile roof be replaced with shingles or metal?
Homes with tile can be reroofed in metal, shingles or other materials, as long as the slope suits the new roof. The eaves, flashing and ventilation are reworked for the new material, and local rules or an HOA may limit the choice.
Is it possible to reuse the existing tile?
Tile that is still hard and intact can be relaid over new underlayment. Some pieces always break during removal, so matching replacement tile is blended in. Brittle or eroded tile is better swapped for new.
More questions? Call (862) 420-3040
Often needed together
Tile Roof Installation
Clay and concrete tile roofs installed over the right underlayment, battens and flashing, whether the home is new or switching from shingles.
Learn moreTile Roof Repair
Repairs for broken tiles, worn underlayment and leaking flashing on clay and concrete tile roofs, without tearing off a roof that still has decades left.
Learn moreRoof Replacement
Replacing an aging roof with new underlayment, flashing, vents and roofing, so the house is dry for decades instead of seasons.
Learn moreTile Roof Inspection
A close look at the tile, underlayment, flashing, valleys and attic of a clay or concrete tile roof, without breaking tile in the process.
Learn more
Looking for something else?
See all roofing servicesTalk to a Boonton roofer about tile roof replacement
Call (862) 420-3040 to talk to a roofer serving Boonton, NJ.